UNPACKING AND SETUP
WHAT’S IN THE BOX
Packed with your D 3045 you will nd:
• Detachable mains power cord
• AMP 3 remote control with 3V CR2025 battery
• Eight pieces of dome-shaped feet
• Quick Setup Guide
SAVE THE PACKAGING
Please save the box and all the packaging in which your D 3045 arrived.
Should you move or otherwise need to transport your D 3045, this is by
far the safest container in which to do so. We’ve seen too many otherwise
perfect components damaged in transit for lack of a proper shipping
carton, so please: Save that box!
QUICK SETUP
This simple guide will help you get started with your D 3045.
Place the D 3045 on a rm, level surface. Do not place the unit on a soft
surface like a carpet.
Make all the connections to your D 3045 with the unit unplugged from
the mains power source. It is also advisable to power down or unplug all
associated components while making or breaking any signal or AC power
connections.
1 Connect applicable speakers to the LEFT and RIGHT SPEAKERS terminal
of D 3045.
2 Using applicable connectors (not supplied), connect source devices to
corresponding input sockets of D 3045.
HDMI $ HDMI ARC
S/PDIF sources $ OPTICAL 1, OPTICAL 2, COAXIAL
Analog sources $ LINE 1, LINE 2, PHONO (MM)
USB sources $Computer
Other sources $ Bluetooth
3 Connect corresponding end of the mains power cord to the AC mains
input of the D 3045 and the plug connected to a mains power source.
4 With all applicable sources hooked up to D 3045 and powered up, press
o (Standby) to switch ON the D 3045 from standby mode.
5 Start listening by rotating the SOURCE knob to select preferred source
input. Rotate Volume control knob to adjust audio level.
RESTORE D3045 TO FACTORY DEFAULT SETTINGS
While at operating mode, press and hold remote control’s “DIM” button
until “Reset” appears in the display and Source defaults to OPTICAL 1.
GETTING STARTED
4
To Next Page
Loading...
Need help?
General
