My chassis or controller does not appear in MAX. How
do I use MAX to identify and configure my PXI system?
If you are using MAX to configure your PXI system, you must install the PXI Platform
Services software on your controller to identify NI PXI and PXI Express chassis and modules
in MAX. You can install PXI Platform Services from the software CD included with your
controller or from ni.com/downloads.
PXI Platform Services version 20.0 or later supports the PXIe-8881.
My CMOS is corrupted. How do I set it back to default?
There are two methods that you can use to reset the CMOS.
1. First Method
a) Enter the BIOS setup program.
b) Press <F9> to load BIOS defaults.
c) Answer Y (Yes) to the verification prompt.
d) Select Save and Exit Setup.
2. Second Method
a) Power off the chassis.
b) Remove the controller from the chassis.
c) Press the Clear CMOS button (SW2) as shown in the following figure.
d) Reinstall the controller in the chassis.
12 | ni.com | PXIe-8881 Getting Started Guide
To Next Page
Loading...
Need help?
General
