GUITAR RIG KONTROL Hardware Reference – 9
2.2.2 Caution
To make sure that the
RIG KONTROL
or any device connected is not damaged during
usage or maintenance, it is important that you follow these instructions:
►
Do not open the device or attempt to disassemble or modify the internal parts. The
device contains no user-serviceable parts. If it appears to be malfunctioning,
discontinue use immediately and have it inspected by qualied service personnel.
► Do not expose the unit to rain, use it near water or in damp or wet conditions.
► Do not allow any objects or liquids of any kind to penetrate the unit.
►
Never use or store the unit in areas that are subject to temperature extremes (e.g.
direct sunlight in an enclosed vehicle or near heat-generating equipment) or high
levels of vibration.
►
Do not place the
RIG KONTROL
in an unstable position where it is possible the unit
could accidentally fall. Remove all connected cables before moving the unit.
►
Before turning the power on or off for any component, set all volume levels to their minimum.
► Do not use excessive force on the knobs or connectors.
►
When cleaning the RIG KONTROL, use a soft, dry cloth. Never use paint thinners,
solvents, cleaning uids or chemical-impregnated wiping cloths.
2.2.3 Disposal Notice
Should this product become damaged beyond repair, or if you wish to dispose it, please observe
the regulations of your area and country that relate to the disposal of electronic products.
2.3 Disclaimer
Native Instruments GmbH cannot be held responsible for damage or lost or destroyed data
caused by improper use or modication to the RIG KONTROL.
The information contained in this manual is believed to be correct at the time of printing
or digital release. However, Native Instruments reserves the right to make changes to the
specications at any time without notice or obligation to update existing units.
To Next Page
Loading...
Need help?
General