Scanning For TV Channels (10” consoles only)
When using the TV function for the first time, the console must scan for available TV channels.
Follow the instructions below to perform the TV channel scan.
1. Ensure the coaxial cable is connected to
the console as described on the previous
page.
2. Connect the power supply to the
machine at the front power inlet and then
connect it to the wall or floor outlet.
3. From the Splash Page, touch and hold
the Nautilus icon for 5 to 10 seconds to
advance to the Setup Page as shown in
Figure 7.
4. Tap the Customize icon to advance to
the Customize Page.
5. Tap the Next icon to advance to Page 3
6. Tap the Auto Scan icon to begin the TV
channel scan as shown in figure 8.
7. When the channel scan is 100%
complete, tap the Back icon once to return
to the Setup Page. Then tap the Exit icon
to return to the Splash Page.
Figure 7
Figure 8
Figure 9
assembly questions? call 800-235-2233 for help.
To Next Page
Loading...
Need help?
General
