105Operating the Boiler
11.5 Accessing Basic Menu Items
In the Main Menu screen, you can view the boiler’s
operating conditions, configure the space heating
and DHW temperatures, and review error history.
Press the Menu button (
) to enter the Main Menu
screen.
11.5.1 Viewing Basic Information
To view information about the boiler, press the
Menu button (
), and then select “1. Status
Information”.
Rotate the Command dial ( ) to switch between
the information items. Press the Command dial (
)
to select an item and view the information.
Press the Back button (
) to exit information view
mode.
Item Description
1. Operation State Current Operation State
2. Heat Capacity Heat Capacity (%)
3. SH Set Temp
Space heating set
temperature (°F)
4. DHW Set Temp DHW set temperature (°F)
5. Press the Command dial (
) to confirm the
new temperature.
6. Press the Back button (
) to return to normal
operation mode, or rotate the Command dial
( ) to adjust other operation conditions.
You can adjust the temperature while the display is
flashing. Once the display stops flashing, the current
temperature setting is stored.
Note
●
The default DHW temperature is 122°F.
●
DHW temperature range is 86°F (30°C)
to 140°F (60°C).
●
The boiler will retain your settings
during a power outage.
11.4.3 Resetting the Boiler
If an error message appears during boiler operation,
reset the boiler to resolve the problem. Press the
Back button (
) on the front panel to reset the
boiler.
If resetting the boiler does not solve the problem,
refer to the Troubleshooting section of this manual
or contact Technical Support at 1-800-519-8794.
To Next Page
Loading...
Need help?
General
