6
Quick Start –continued
Removing the Base
Note: Always remove the Base when shipping the LCD.
1.
Place monitor face down on a non-abrasive sur
face.
2. Using your thumbs, press the quick release button
to unlock the stand.
3. Pull the unlocked base off the stand.
Connecting a Flexible Arm
This LCD monitor is designed for use with a fl exible arm. Please use the attached
screws (4pcs) as shown in the picture when installing.
To meet the safety requirements, the monitor must be mounted to an arm which
guaranties the necessary stability under consideration of the weight of the monitor.
The LCD monitor should only be used with an approved arm (e.g. GS mark).
Specifi cations
If using other screws,
check depth of holes.
4-SCREWS (M4)
Thickness of Bracket
(Arm) 2.0~3.2 mm
(MAX depth: 8.5 mm)
Weight of LCD assembly:
4.2 kg (MAX)
Tighten all
screws.
100 mm
Quick release button
100 mm
12mm
M4
4 x 12mm with lock
washer and flat washer
To Next Page
Loading...
Need help?
General