English-24
ZOOM The image can be expanded/reduced.
NOTE: The expanded image which is outside of active display area is not shown. The reduced
image may have some image degradation.
-
ZOOM Maintains the aspect ratio while zooming. -
HZOOM Amount of horizontal zoom.
VZOOM Amount of vertical zoom.
H POS Horizontal position.
V POS Vertical position.
IMAGE FLIP NOTE: When the ASPECT is DYNAMIC, the image will be changed to FULL image before
IMAGE FLIP, then start to IMAGE FLIP. This function is not available when MOTION in SCREEN
SAVER or ROTATE is “ON”.
When selecting IMAGE FLIP except for NONE, following functions are released:
MULTI PICTURE MODE, TEXT TICKER, STILL, POINT ZOOM and ROTATE.
When input signal is Interlace, the image may be disturbed.
-
IMAGE FLIP Display the inverse image right-left, up-down or rotation.
Press + or - to select.
NONE
NONE
Normal mode.
-
H FLIP
The image inverts right-left.
-
V FLIP
The image inverts up-down.
-
180° ROTATE
The image rotates 180 degrees.
-
OSD FLIP Determines the OSD display direction.
If “ON” is selected, OSD will invert depending on the image.
OFF
RESET Resets “ADJUST” settings back to factory settings. -
AUDIO
VOLUME Increases or decreases output volume level. 40
BALANCE
Select “STEREO” or “MONO” of audio output.
If you select “STEREO”, adjust the balance of L/R volume.
Press + button to move the stereo sound image to right.
Press - button to move the stereo sound image to left.
CENTER,
STEREO
TREBLE To accentuate or reduce the high frequency sound.
Press + button to increase TREBLE sound.
Press - button to decrease TREBLE sound.
0
BASS To accentuate or reduce the low frequency sound.
Press + button to increase BASS sound.
Press - button to decrease BASS sound.
0
SURROUND Artifi cial surround sound.
NOTE: LINE OUT is disabled when this function is set to “ON”.
OFF
MULTI PICTURE AUDIO Selects source of MULTI PICTURE AUDIO.
NOTE: This function depends on MULTI PICTURE setting.
PICTURE 1
LINE OUT Selecting “VARIABLE” enables control of the line out level with the VOLUME button. FIXED
AUDIO INPUT Selects audio input source LINE IN, DPORT, HDMI1, HDMI2, HDMI3, HDMI4, OPTION*
1
. Depends on
signal input
AUDIO DELAY Enables to set the delay time to output the audio. DELAY TIME can be set between 0 and
100 milliseconds. “ON” activates this function.
ON,
37 MSEC.
RESET Resets “AUDIO” options back to factory settings except VOLUME. -
SCHEDULE
OFF TIMER
Sets the monitor to power off after a length of time.
A time between 1 to 24 hours is available.
OFF/1 HOUR
SCHEDULE SETTINGS Creates a working schedule for the monitor to use. -
*1: This function depends on which option board you use.
To Next Page
Loading...
Need help?
General