en Trouble shooting
38
--------
Maximum operating time exceeded
Your appliance ends the operation automatically when
no cooking time is set and the setting has not been
changed for a long time.
The actual cooking time until the operation is stopped
automatically varies according to the selected settings.
The appliance display indicates that the operation will
end automatically. Afterwards, the operation is stopped.
To use the appliance again, switch it off beforehand.
Then switch the appliance on again and set the
required operation.
Cooking compartment bulbs
To light the interior of your cooking compartment, your
appliance has one or more long-life LED bulbs.
However, if ever an LED bulb or the bulb's glass cover
is defective, call the after-sales service. The lamp cover
must not be removed.
The panel for removing the tank does
not open
The plug is not plugged into the mains Connect the appliance to the power supply
Power cut Check whether other kitchen appliances are working
The circuit breaker is faulty Check in the fuse box to make sure that the fuse for
the appliance is OK
Faulty sensor for the ” touch button Call the after-sales service
If required, empty the water tank: Open the appliance
door, take hold of the lower part of the panel on the
left and right with your fingers and pull out the panel
The appliance cannot be switched on;
the 1 symbol is shown on the dis-
play
The automatic childproof lock is activated Press and hold the 0 touch button until the 1 sym-
bol goes out
The appliance cannot be operated
when it is switched on; the 1 symbol
is shown on the display
The childproof lock is activated Press and hold the 0 touch button until the 1 sym-
bol goes out
The appliance does not heat up; 6 is
shown on the display
Demo mode is activated in the basic settings Disconnect the appliance from the mains for approx.
10 seconds (switch off the circuit breaker in the fuse
box) and then deactivate demo mode in the basic set-
tings within 3 minutes
~ "Basic settings" on page 22
There is a "pop" noise during cooking Cold/warm effect with frozen food, caused by the
steam
Not possible
"D" or "E" appears on the display, e.g.
D0111 or E0111
Technical problem Switch the appliance off and on again
If the message appears again, call the after-sales ser-
vice. Quote the exact error message
Home Connect does not work cor-
rectly.
Go to www.home-connect.com
To Next Page
Loading...
Need help?
General
