NEFF S353ITX00E User Manual

Basic settings en
31
Basic settings
Basic settings
Basic settings
You can configure the basic settings for your appliance to meet your needs.
Overview of basic settings
The basic settings depend on the features of your appliance.
Basic setting Selection Description
Water hardness Scale with 4 levels Set the water hardness.
→"Setting the water softening
system", Page21
Rinse aid disp. Scale with 4 levels Set the amount of rinse aid to
be dispensed or switch off.
→"Setting the amount of rinse
aid", Page24
Extra Dry On
Off
1
Switch Extra Dry on or off for
each operation.
For a better drying result the
temperature in the final rinse is
increased. This may increase
the running time slightly.
Note:Please take care with del-
icate tableware.
→"Setting Extra Dry",
Page31
Tone volume Scale with 4 levels Adjustment of tone volume.
→"Setting signal volume",
Page32
Factory setting Reset Restore changed settings to the
factory settings.
The settings for initial start-up
must be configured.
→"Restoring factory settings",
Page32
1
Factory setting (may vary according to model)
Setting Extra Dry
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a is flashing on the display.
3. Press repeatedly until
and flash in the display.
4. Press repeatedly until the
LEDs show the right value.
If "LED A" →Page15 is not lit, Ex-
tra Dry is switched off.
If "LED A" →Page15 is lit, Extra
Dry is switched on.
5. To save the settings, press
for 3 seconds.

NEFF S353ITX00E Specifications

General

Brand	NEFF
Model	S353ITX00E
Category	Dishwasher
Language	English