| Wireless M2M
13
NTC-140W Series - 4G WiFi M2M Router
Wireless LAN connection
The NTC-140W Series router can operate as both an access point and a WiFi
client simultaneously, if required. By default the NTC-140W Series router has the
Wireless LAN enabled and operates as an access point only.
Connecting a wireless client to the NTC-140W access point
The WiFi Network Name (SSID) and WiFi Security Key are unique for your device
and are printed on the back of your NTC-140W Series router. The credentials are
also printed on the Wireless Security Card.
Follow these steps to connect your client device to the Internet over the
wireless network:
1. Turn on the wireless radio on your client device.
2. Open the wireless network manager on your client device and connect to the
Wireless Network Name (SSID) printed on the Wireless security card.
3. When prompted for your wireless security settings, enter the Wireless Security
Key. Wait a few seconds for the connection to be established.
Wireless Security Card
Keep this card in a secure place for easy access
to your NetComm Wireless M2M device
Wireless Network Name (SSID) NetComm 1234
Wireless Security Key ABCDE12345
IMEI 123456789123456789
To Next Page
Loading...
Need help?
General
