•
Store-and-forward transmission to remove bad packets from the network.
•
Active flow control to minimize packet loss and frame drops.
•
Half-duplex backpressure control.
•
Per-port status LEDs and system status LEDs:
- System Power LED
- Cloud Connection LED
- PoE Max or Fault LED (models GC728XP and GC752XP)
- Fan LED
-
Per-port link, speed, and activity LED for copper ports
-
Per-port PoE status LED for copper ports (models GC728XP and GC752XP)
-
Per-port link and activity LED for SFP and SFP+ fiber ports
•
NETGEAR green power-saving features:
-
Energy efficiency mode that fully conforms to the IEEE 802.3az standard
- Per-port automatic change to a lower power mode when the port link is down
Safety Instructions and Warnings
Use the following safety guidelines to ensure your own personal safety and to help
protect your system from potential damage.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment,
observe the following precautions:
•
This product is designed for indoor use only in a temperature-controlled (0–45°C)
and humidity-controlled (90 percent maximum relative humidity, noncondensing)
environment.
Any device that is located outdoors and connected to this product must be properly
grounded and surge protected.
To the extent permissible by applicable law, failure to follow these guidelines can
result in damage to your NETGEAR product, which might not be covered by
NETGEAR’s warranty.
Hardware Installation Guide10Introduction
Insight Managed 28-Port and 52-Port Gigabit Ethernet (PoE+) Smart Cloud Switch
To Next Page
Loading...
Need help?
General
