Installation Guide
NETGEAR Smart Switch™ GS728TP, GS728TPP, GS752TP
Package Contents
• NETGEAR Smart Switch™ GS728TP, GS728TPP, or GS752TP
• Rubber footpads for tabletop installation
• AC power cord
• 19-inch rack-mount kit for rack installation
• Installation guide
• Smart Switch resource CD that includes the Smart Control Center Utility and
hardware installation guide. (A link to the online software administration manual
is on the resource CD.)
Configure the Switch
Install the Smart Control Center Utility and use it to configure the switch.
Install the Smart Control Center Utility on a Computer
1. Insert the resource CD into your CD drive.
2. Run the Setup program to install the Smart Control Center Utility.
The Installation Wizard guides you through the installation.
Connect Your Smart Switch
These instructions assume you are using DHCP in your network. If you are using
static IP addressing in your network, configure the switch IP address before
connecting the switch to your network. If there is no DHCP server, the switch IP
address will default to 192.168.0.239.
1. Set up the computer with a static IP address in the 192.168.0.x subnet, and
connect the computer to the switch. Then, use the Smart Control Center Utility
to configure the switch.
2. Connect each computer to an RJ-45 network port on the switch front panel.
Use Category 5 (Cat 5) unshielded twisted-pair (UTP) cable terminated with an
RJ-45 connector to make these connections.
3. Connect the switch to your network.
4. Power on the switch.
5. Verify that the computer with the Smart Control Center Utility is on the same
subnet as the switch.
Configure the Switch with the Smart Control Center
Utility
1. Double-click the Smart Control Center Utility icon on your desktop or in
the Windows Start menu to run the utility and view this screen.
2. Click Discover to find your switch in the network.
To Next Page
Need help?
General