NETGEAR RAX10 User Manual

To wall-mount your router:
1. Drill holes in the wall where you want to wall-mount your router.
2. Insert wall anchors in the holes.
3.
Insert screws into the wall anchors, leaving 3/16 inch (0.5 cm) of each screw exposed.
4. Align the router’s wall-mounting holes with the screws and mount your router.
Cable your router
Power on your router and connect it to a modem.
Figure 6. Cable your router
To cable your router:
1.
Unplug your modem, remove and reinsert the backup battery if it uses one, and
then plug the modem back in.
2. Use the Ethernet cable to connect the modem to the yellow Internet port on the
router.
Note: If your Internet connection does not require a modem, connect your main
Ethernet cable to the yellow Internet port on the router.
3. Connect the power adapter to your router and plug the power adapter into an outlet.
The router’s Power LED lights solid green when the router is ready.
User Manual15Hardware Setup
4-Stream AX1800 WiFi 6 Router

NETGEAR RAX10 Specifications

General

Brand	NETGEAR
Model	RAX10
Category	Wireless Router
Language	English