NEUTON CE6.2 Battery-Powered Mower -
Safety & Operating Instructions
43
Troubleshooting Table - continued
PROBLEM CORRECTIVE ACTION
The Battery LED
does not turn RED
when the Charger
is connected.
⇒ Unplug the Battery Charger from your standard 110V wall outlet and from the
Charger Receptacle on the Battery. Inspect the Battery Charger for any visible signs
of damage to the body and the cord. If you observe damage to the Battery Charger,
please discontinue use.
Use of a damaged Battery Charger may cause a short circuit and the potential for a
fire.
⇒ Inspect the Charger Receptacle on the Battery for any signs of visible damage or
debris. If there is debris present, please use caution to remove the debris.
Do not remove the debris with any metallic objects, damp or flammable items, or
items that may become lodged in the Charger Receptacle as this may cause a fire, or
explosion of the Battery. If you observe damage to the Charger Receptacle, please
discontinue use.
Use a vacuum equipped with a non-metallic nozzle to remove debris from the
Charger Receptacle on the Battery.
NOTE: You can damage the Charger Receptacle by excessive force. It should not take a great
amount of force to insert the round Charger Connector. Please do not force the round
Charger Connector into the Charging Receptacle on the Battery.
The Battery
Charger LED does
not come on when
plugged into a
standard 110V
wall outlet.
⇒ Unplug the Battery Charger from your standard 110V wall outlet and from the
Charger Receptacle on the Battery. Inspect the Battery Charger for any visible signs
of damage to the body and the cord. If you observe damage to the Battery Charger,
please discontinue use.
Use of a damaged Battery Charger may cause a short circuit and the potential for a
fire.
⇒ Verify your Standard 110V wall outlet is functioning correctly by plugging a lamp or
other electrical device into the same socket on the wall outlet you are intending to
use.
TIP
To Next Page
Loading...
Need help?
General
