TECHNICAL HANDBOOK LW 50
373179329 01
Organizational measures 2800456
The operating instructions must always be at
hand at the place of use of the machine, e.g. by
stowing them in the tool compartment or tool-box
provided for such purpose.
In addition to the operating instructions, observe
and instruct the user in all other generally ap-
plicable legal and other mandatory regulations
relevant to accident prevention and environmental
protection.
These compulsory regulations may also deal with
the handling of hazardous substances, issuing
and/or wearing of personal protective equipment
or traffic regulations.
The operating instructions must be supplemented
by instructions covering the duties involved in
supervising and notifying special organizational
features, such as job organization, working se-
quences or the personnel entrusted with the
work.
Personnel entrusted with work on the machine
must have read the operating instructions and in
particular the chapter on safety before beginning
work. Reading the instructions after work has be-
gun is too late. This applies especially to persons
working only occasionally on the machine, e.g.
during setting up or maintenance.
Check - at least from time to time - whether the
personnel is carrying out the work in compliance
with the operating instructions and paying atten-
tion to risks and safety factors.
For reasons of security, long hair must be tied
back or otherwise secured, garments must be
close-fitting and no jewellery, such as rings, may
be worn. Injury may result from being caught up
in the machinery or from rings catching on mov-
ing parts.
Use protective equipment wherever required by
the circumstances or by law.
Observe all safety instructions and warnings at-
tached to the machine.
See to it that safety instructions and warnings
attached to the machine are always complete and
perfectly legible.
In the event of safety-relevant modifications or
changes in the behaviour of the machine during
operation, stop the machine immediately and re-
port the malfunction to the competent author-
ity/person.
Never make any modifications, additions or con-
versions which might affect safety without the
supplier's approval. This also applies to the in-
stallation and adjustment of safety devices and
valves as well as to welding work on load-bearing
elements.
Spare parts must comply with the technical re-
quirements specified by the manufacturer. Spare
parts from original equipment manufacturers can
be relied to do so.
Replace hydraulic hoses within stipulated and ap-
propriate intervals, even if no safety-relevant de-
fects have been detected.
Adhere to prescribed intervals or those specified
in the operating instructions for routine checks
and inspections.
For the execution of maintenance work, tools and
workshop equipment adapted to the task on hand
are absolutely indispensable.
The personnel must be familiar with the location
and operation of fire extinguishers.
Observe all fire-warning and fire-fighting proce-
dures.
To Next Page
Loading...
Need help?
General
