26 – English
Manual movement and release: before carrying out this operation please note that release can only occur when
the leaf is stopped.
To lock: carry out the same procedures backwards.
Control with safety devices out of order: If the
safety devices are malfunctioning, it is still possible to
control the gate.
• Operate the gate control device (remote control or
key-operated selector switch, etc.). If the safety
devices enable the operation, the gate will open and
close normally, otherwise the flashing light flashes
a few times but the manoeuvre does not start (the
number of flashes depends on the reason why the
manoeuvre is not enabled).
• In this case, actuate the control again within 3
seconds and keep it actuated.
• After approximately 2s the gate will start moving in
the “man present” mode, i.e. so long as the control
is maintained the gate will keep moving; as soon as
the control is released the gate will stop.
If the safety devices are out of order the auto-
mation must be repaired as soon as possible.
Replacing the Remote Control Battery: if your radio
control, after a period of time, seems not to work as
well, or not to work at all, it may simply be that the bat-
tery is exhausted (depending on the type of use, it may
last from several months up to one year and more).
In this case you will see that the light confirming the
transmission is weak, or does not come on, or comes
on only briefly. Before calling the installation technician
try exchanging the battery with one from another ope-
rating transmitter:
if the problem is caused by a low battery, just replace
it with another of the same type. The batteries contain
polluting substances: do not dispose of them together
with other waste but use the methods established by
local regulations.
1 Slide the lock cover disc 2 Insert and turn the key clockwise.
3 Pull the release handle 4 Move the leaf manually.
To Next Page
Loading...
Need help?
General
