23
GB
7.8) Accessories
The following optional accessories are available for RUN:
• SMXI or SMXIS: Radio receiver at 433.92MHz with digital Rolling
Code encoding.
• ONEXI: Radio receiver at 433.92MHz with digital Rolling Code
encoding; equipped with Modo III to send 15 types of command
to control unit
• OperaView; Remote programming unit.
Consult the Nice S.p.a. product catalogue for the complete and
updated list of accessories.
Led 1 Description
• Function programming in progress.
• If flashing with L4 indicates need for device self-learning phase (see paragraph “4.3 Device self-learning”)
Led L6 Description
Led L5 Description
Led L3 Description
Led L2 Description
Led L4
Description
During normal operation indicates “Thrust” not active.Off
Off
Table 23: leds on control unit keys
During normal operation indicates “Automatic closing” not active
During normal operation indicates “Automatic closing” active
• Function programming in progress
• If Flashing with L2 indicates need for device self-learning phase (see paragraph “4.3 Device self-learning”).
On
Flashing
Off During normal operation indicates “Reclose after Photo” not active
During normal operation indicates “Reclose after Photo” active
• Function programming in progress.
• If flashing with L1, indicates need for device self-learning phase (see paragraph “4.3 Device self-learning”)
On
Flashing
Off During normal operation indicates “Always close” not active.
During normal operation indicates “Always close” active.
During normal operation the device indicates “Stand-by” not active.
During normal operation the device indicates “Stand-by” active.
• Function programming in progress.
• If flashing with L3 indicates need for leaf length self-learning phase (refer to Paragraph “4.4 Leaf length
Self-learning”).
On
Flashing
Off
On
Flashing
During normal operation indicates “Thrust” active.
Function programming in progress.
On
Lampeggia
During normal operation indicates “Pre-flash” not active.
During normal operation indicates “Pre-flash” active.
Function programming in progress
Off
On
Flashing
Led L7 Description
During normal operation indicates that the CLOSE input activates a close manoeuvre
During normal operation indicates that the CLOSE input activates a partial opening manoeuvre.
Function programming in progress
Off
On
Flashing
Led L8 Description
During normal operation indicates that RUN is configured as Master
During normal operation indicates that RUN is configured as Slave
Function programming in progress
Off
On
Flashing
7.8.1) Remote programming unit
More specifically, connector BusT4 (see figure 30) enables connec-
tion of the remote programming unit Oview which enables complete
and rapid management of installation, maintenance and trou-
bleshooting of any malfunctions.
To access the connector, remote the membrane as shown in figure
31. The remote programming unit can be placed at a distance from
the control unit, with up to 100m of cable; it can be connected simul-
taneously to up to 16 and can remain connected during normal
operation of RUN; in this case a specific “user” menu enables deliv-
ery of commands to the control unit.
If a OXI (o OXIT) type radio receiver is inserted in the control unit, the
remote programming unit enables access to the parameters of the
memorised transmitters.
These functions require a 4-core connection cable (BusT4).
The RUN control unit firmware can also be updated. Further infor-
mation is available in the Oview programmer instruction manual.
IMPORTANT – For further details on all functions of the NiceOpera
system and interdependency of the various devices in the system,
refer to the general manual “NiceOpera System Book”, also available
on the Internet site www.niceforyou.com.
30 31
To Next Page
Loading...
Need help?
General
