English – 3
1
PRODUCT DESCRIPTION AND INTENDED USE
This product is intended to be used to automate swing gates. CAUTION! – Any use other than the intended use, and any use in conditions
other than those described in this manual, is improper and forbidden!
The product is an electromechanical gearmotor, available in two versions:
24V : TOO3024 - TOO4524
230V : TOO3000 - TOO4500
120V : TOO3000/V1 - TOO4500/V1
It is equipped with a 24V - 120 V DC motor or 220V AC motor (depending on the version) and a worm screw reduction unit.
The gearmotor is powered off the external control unit to which it is connected. WARNING! – With the motors TOO3024 and TOO4524, only
the control unit model MC424LR01 can be used!
In case of power outage, the gate can be operated manually by disengaging the gearmotor (par. 3.1).
2
APPLICATION LIMITS
Caution! - The motor must be installed by qualied personnel in compliance with current legislation, standards and regulations, and
the directions provided in this manual.
Before proceeding with the installation:
- Check that the area to which the gearmotor is to be mounted is large enough.
TOO3000 - TOO3024 - TOO3000/V1
- Check the gate’s opening movement and the force exerted by the motor: these depend on the position of the rear bracket.
1100 mm : TOO3000 - TOO3000/V1 - TOO3024
1300 mm : TOO4500 - TOO4524/V1 - TOO4524
107 mm :
TOO3000 - TOO3024
TOO3000/V1
142 mm :
TOO4500 - TOO4524
TOO4524/V1
To Next Page
Loading...
Need help?
General
