62mm snap-on front lens cap
Rear lens cap LF-1
Hand lens case CL-33S
Plastic case CP-9
Screw-in hood HN-22
62mm screw-in filters
Teleconverter TC-200
Teleconverter TC-201
Teleconverter TC-14A
Soft lens case No, 62
LENS CARE
• Althouogh you should always keep the lens surfaces clean, rough cleaning
must be avoided. Wipe with a soft, clean cotton cloth moistened with alcohol to
remove grease or fingerprints from the lens surfaces.
If you use ether in cleaning the lens, a smudge sometimes appears on the
surface of a multi-coated lens. If this happens, wipe it again with a cotton cloth
moistened with alcohol.
• To protect the lens surface from dirt or damage, the use of an L37C or L1BC
filter is recommended at all times. The lens hood also helps to protect the lens.
• Keep the lens cap in place whenever the lens is not in use.
• Attach both the front and rear caps when the lens is stored separately.
• To ensure proper fit of the lens when stored in the leather lens case, set the
lens'
focusing ring to the infinity (*>) setting.
13
To Next Page
Loading...
Need help?
General
