- Ｄ ･ -
VBA18001-R.3719.A
logo�Q0440�forGraphic
070518�Gdesign�ito
Precautions for disassembly/(re)assembly
Notes
：
①
In disassembly/(re)assembly, be sure to use conductive mat (J5033) and wrist strap (J5033-5), in order to protect electric
parts from static electricity.
Before disassembling, be sure to remove batteries, AC power cord, and battery for clock (CR1616).
In disassembling, be sure to memorize the processing state of wires and FPC, screws to be xed and their types, etc.
The low-pass lter of the image PCB is easily damaged. Handle it very carefully.
In the chapter of Disassembly, sometimes a large assembly unit is removed. In case such a unit is further disassembled,
refer to the exploded technical drawings.
In Disassembly/(re)assembly chapters, the sponge and tape are not mentioned. In case parts are replaced, be sure to
attach the sponge/tape by referring to the exploded technical drawings.
All wires are special parts (supporting UL), so be sure to use specied wires.
is indicated in this manual when NK screw is used. Usually the same "NK" screw can be used approx. up to three
times. (NK screw = Loose-proong screw to which the adhesive is already applied and rmly xed when screwed in.)
1. External units and Imaging-related PCBs
Disassembly
Note : When "Separating Front and Rear bodies", "Disassembling Image PCB", and "Disassembling Bayonet", be sure to
perform "Reset of AF defocus compensation amount" by the adjustment software after reassembly.
External rubber
・
Remove the grip rubber (#B60), apron lower rubber
(#B66), and connector side rubber (#B61).
Points to notice for Lead-free solder products
・ Lead-free solder is used for this product.
・ For soldering work, the special solder and soldering iron are required.
・ Do NOT mix up lead-free solder with traditional solder.
・ Use the special soldering iron respectively for lead-free solder and lead solder.
They cannot be used in common.
NK
#B61
#B66
#B60
#65
#62
To Next Page
Loading...
Need help?
General
