SC3000 26” Disc / 28” Cyl. 9098827000(2)2010-12
25
INSTRUCTIONS FOR USE
ENGLISH
SIDE SKIRT CHECK AND REPLACEMENT (only for 28” Cyl.)
Check
Drive the machine on a level fl oor.1.
Turn the ignition key (58) to “0”.2.
On both sides of the machine, unscrew the knob (A, Fig. 8) and remove the side skirt assemblies (B).3.
Wash and clean the skirt.4.
Check that the skirt lower edge (C):5.
lays down on the same level, along all its length;•
is integral and free from cuts and lacerations;•
has the inner corner (D) that is not worn;•
Otherwise overturn or replace the skirts according to the following procedure.
Overturning or replacement
Remove the wing nuts (E), then remove the retaining strip (F).6.
Remove the skirt blade (G) and, if possible, overturn the blade to replace the lower inner corner (D) with an integral one. If the 7.
other three corners are worn too, replace the blade.
Assembly and height adjustment
Assemble the blades (G) and skirt assembly (B) in the reverse order of disassembly.8.
Start the machine and lower the cylindrical brush deck (28), then check that the side skirt blades (G):9.
slightly touch the fl oor;•
collect the solution. •
If necessary stop the machine and adjust the skirt height by loosening the knob (A) and turning the knobs (H).10.
After adjusting, tighten the knob (A).11.
H
A
A
H
B
E
C
E
F
F
I
G
D
E
Figure 8
P100369
To Next Page
Loading...
Need help?
General
