Ninja BL685 User Manual

Troubleshooting Guide
PROBLEMS
Motor doesn't start or blade
assembly doesn't rotate .
Food is unevenly chopped.
Food is chopped too fine or is
too watery .
Food collects on lid or on the
sides of the container.
You cannot achieve snow
from solid ice.
Motor base won't stick to
counter or table top.
Leaking is occurring when
using the Nutri Ninja® cup.
Ingredients are stuck and not
fully blending.
The Nutri Ninja button does
not work.
Replacement Parts
ORDERING REPLACEMENT PARTS
POSSIBLE REASONS & SOLUTIONS
Make sure the container is securely placed on motor base .
Make sure the lid is securely on container in the correct position (align arrows) .
The appliance is turned "Off ". Press the power button (6) to turn "On ".
Check that the plug is securely inserted into the electrical outlet.
Check the fuse or circuit breaker.
The unit has overheated or overloaded . Unplug and wait approximately 15
minutes before using again .
Either you are chopping too much food at one time, or the pieces are not of
an even size . Try processing smaller amounts per batch.
The food has been over processed . Use pulse button for controlled
processing .
The mixture is to thick. Add more liquid .
Do not use ice that has been sitting out or has started to melt. Use ice
straight from the freezer.
Make sure surface and suction feet are wiped clean. Suction feet will only
stick to smooth surfaces. Suction feet WILL NOT stick on some surfaces
such as, wood, tile and non-polished finishes.
DO NOT attempt to use appliance when the motor base is stuck to a
surface that is not secure , (cutting board , platter, plates , etc .).
Ensure the blade is properly twisted into the cup and sealed tightly into
place . Check to see that the lid gasket is properly in place .
Do not overfill the cup . Never add ingredients past the " Max" fill line .
You may have overloaded the Nutri Ninja cup . Try pulsing 3-5 times and
then resume blending. You may also add liquid to make blending easier.
The Nutri Ninja button will only operate when you have the Nutri Ninja
cup assembled to the motor base. This function was designed specifically
for the Nutri Ninja Cups to operate at the ideal speed. This function is
programmed to shut off after 30 seconds.
To order additional parts and attachments, please visit our website : ninjaaccessories . com
or feel free to contact customer service : 1-877-646-5288 .
ninjakilchen.com [ 12
BL685_Series_lB_ 170428_press.indd 13
2017-05-01 9:08
AM I
Case 2:23-cv-02144 Document 1-1 Filed 03/20/23 Page 13 of 16 PageID #: 24

Ninja BL685 Specifications

General

Brand	Ninja
Model	BL685
Category	Blender
Language	English