Nokia 6010 User Guide 47 Copyright © 2004 Nokia
Voice features
Existing voice command
After you have associated a voice tag to a command, you can either play back,
change or delete the tag.
PLAY BACK
1 Select Menu > Extras > Voice commands > Audible alerts and the voice
command tag you want to play back.
2 Select Options > Playback.
CHANGE
1 Select Menu > Extras > Voice commands > Audible alerts and the voice
command tag you want to change.
2 Select Options > Change > Start, then speak the voice tag clearly into the
microphone.
DELETE
1 Select Menu > Extras > Voice commands > Audible alerts and the voice
command tag you want to delete.
2 Select Options > Delete > OK.
• AUDIBLE ALERTS
Audible alerts provide you with audible tones to indicate the current signal bar or
battery bar strength of your phone. In order to obtain audible alerts, the alerts must
first be set up as voice commands. To set up voice commands, see “Add a voice tag”
on page 46.
Select and hold Contacts and speak the voice tag clearly into the microphone.
When the phone finds the tag, confirmation appears and the phone plays the
recognized voice tag from the phone memory through the earpiece. The phone
then beeps to indicate how strong the battery or signal strength is. The following
table shows what the number of beeps indicates.
Audible Alert One Beep Two Beeps Three
Beeps
Four Beeps
Battery Bar
Strength
Low Half full Almost full Full
Signal Bar
Strength
Weak Somewhat
strong
Almost
strong
Strong
To Next Page
Loading...
Need help?
General
