ENGLISH
Clear settings or reset
To clear all the settings from the
headset, switch off the headset, and
press and hold the multifunction key
for about 8 seconds. The headset
beeps twice, and the red and green
indicator lights alternate. After the
settings are cleared, the headset
enters pairing mode.
To reset the headset if it stops
functioning, even though it is charged,
connect the headset to a charger
while you press and hold the
multifunction key.
Troubleshooting
If you cannot connect the headset to
your compatible device, make sure the
headset is charged, switched on, and
paired with your device.
Battery and charger information
This device has an internal,
nonremovable, rechargeable battery.
Do not attempt to remove the battery
from the device, as you may damage the
device. This device is intended for use
when supplied with power from the
following chargers: AC-3, AC-4, AC-5,
AC-8, DC-4, and DC-9. The exact charger
model number may vary depending on
the type of plug. The plug variant is
identified by one of the following: E, EB,
X, AR, U, A, C, K, B, or UB. The battery can
be charged and discharged hundreds of
times, but it will eventually wear out.
Recharge your battery only with Nokia
approved chargers designated for
this device.
If a battery is being used for the first time
or if the battery has not been used for
a prolonged period, it may be necessary
to connect the charger, then disconnect
and reconnect it to begin charging the
To Next Page
Loading...
Need help?
General
Weight and Dimensions
