12
12 © 2010 Nokia. All rights reserved.
To end the active call on one
connected device and make the
call on hold active on the other
device, press the multifunction
key.
To switch between the active call
on one device and the call on hold
on the other device, press and hold
the multifunction key for about 2
seconds.
Clear pairings
To clear the pairings from the
headset, switch off the headset,
and press and hold the
multifunction key for about 8
seconds. The headset beeps twice,
the red and green indicator lights
alternate, and the headset enters
pairing mode.
Troubleshooting
If you cannot connect the headset
to your compatible device, check
that the headset is charged,
switched on, and paired with the
device.
Battery and charger information
This device has an internal,
nonremovable, rechargeable battery.
Do not attempt to remove the battery
from the device as you may damage
the device. This device is intended for
use when supplied with power from
the following chargers: AC-3, AC-4,
AC-5, AC-8, DC-4 and DC-9. The
exact charger model number may
vary depending on the type of plug.
The plug variant is identified by one
of the following: E, X, AR, U, A, C, K,
or B. The battery can be charged and
To Next Page
Loading...
Need help?
General
