Copyright © 2006 Nokia. All rights reserved.
Connectivity
76
Tip! If you have searched for devices earlier, a
list of the devices that were found previously is
shown first. To start a new search, select More
devices. If you switch off the device, the list is
cleared.
Device icons:
—Computer; —Phone; —Audio or video;
—Headset; —Other.
To interrupt the search, press Stop. The device list
freezes.
3 Select the device with which you want to connect.
4 If the other device requires pairing before data can be
transmitted, a tone sounds, and you are asked to enter
a passcode. See “Pair devices”, p. 76.
5 When the connection has been established, Sending
data is shown.
The Sent folder in Messaging does not store messages
sent using Bluetooth connectivity.
Tip! When searching for devices, some devices may
show only the unique addresses (device addresses).
To find the unique address of your device, enter the
code *#2820# in the standby mode.
Pair devices
Glossary: Pairing means authentication. The users of
the two devices with Bluetooth wireless technology
should agree on a common passcode, and use the
same passcode for both devices in order to pair
them. Devices that do not have a user interface have
a factory-set passcode.
In the Bluetooth main view, press to open the paired
devices view ( ).
Before pairing, create your own passcode (1—16 digits),
and agree with the owner of the other device to use the
same code. The passcode is used only once.
To pair with a device, select Options > New paired device.
Devices with Bluetooth wireless technology that are within
range start to appear on the display one by one. Select the
device, and enter the passcode. The same passcode must be
entered on the other device as well. After pairing, the
device is saved to the paired devices view.
Paired devices are indicated by in the device search.
Tip! To define a short name (nickname or alias) for
a paired device, scroll to the device, and select
Options > Assign short name in the paired devices
view. This name helps you to recognise a certain
device during device search or when a device
requests a connection.
To Next Page
Loading...
Need help?
General
