Owner’s Manual 10
Over heating shut-o device operation:
Operating the refrigerator in high ambient temperatures can over heat the cooling unit and cause premature failure of the compressor
(See the label inside the refrigerator).
Toprotectthecoolingunitfromoverheating,therefrigeratorwillautomaticallyshut-owhenthetemperatureofthepowermoduleishigher
than 212° F (100° C). The refrigerator will not restart until the temperature of the power module is lower than 176° F. (80° C).
Low voltage protection system:
The voltage required to start the refrigerator initially is 10.9 volts. In order to prevent completely draining the battery, the refrigerator will
automaticallyshut-owhentheDCsupplyvoltagebecomestoolow.TherefrigeratorwillnotrestartuntiltheDCsupplyvoltagesincreases.
Theseshut-oandrestartvoltagelevelsare:
12VDC Operation
Shut-o 10.4VDC
Restart 11.8 VDC
Over current protection system:
Your refrigerator has an over current protection system in the electronic circuit to prevent damage to the inverter which may occur due
to a reverse polarity connection.
If the refrigerator does not operate and the blue power light does not come on, check the fuse, which is located in-line with the DC
connector, and the polarity of the DC power supply. If the refrigerator still does not operate, another problem can exist in the power
module. Have an authorized Norcold Service Center check the refrigerator.
Read and understand the following maintenance sections of this manual.
Norcold is not responsible for installation, adjustment, alteration, service, or maintenance performed by
anyone other than an authorized Norcold Service Center.
Have an authorized Norcold Service Center do these annual safety and maintenance checks:
- Make sure the DC voltages are correct (See the “Electrical current necessary” section).
- The wire connections must be clean, tight and free of corrosion. If any of these items are not correct:
- A voltage drop to the refrigerator will occur.
- The voltage drop will decrease the cooling performance of the refrigerator.
Disconnect the positive (+) DC power supply wire from the battery before you do a “fast charge” of the
battery. Failure to disconnect the positive (+) power supply wire from the battery during a “fast charge” can
cause damage to the refrigerator or other 12 volt DC appliances.
- Make sure the area at the rear of the refrigerator is free of anything, especially combustible materials, gasoline, and other
ammablevaporsandliquids.
You may purchase replacement parts through your dealer or an authorized Norcold Service Center.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualied
persons in order to avoid a hazard.
- The LED lamps can only be replaced by the manufacturer, together with part of the appliance.
Refrigerator Maintenance Checklist
!
Replacement Parts
!
To Next Page
Loading...
Need help?
General
