Norcold N8DC Series User Manual

Owner’s Manual 9
Door sealing:
If the door does not seal correctly, excess frost will collect inside the refrigerator. Make sure the door seals correctly:
- Close the door on a piece of paper that is about the size of a dollar bill (See Art00980).
- Gently pull the paper.
- You should feel a slight drag between the gasket and the cabinet.
- Do this on all four sides of the door.
- If you do not feel a slight drag on the paper, the door is not sealing correctly.
- Have your dealer or an authorized Norcold Service Center correct the seal of the
door.
Refrigerator Storage:
Before the refrigerator is stored for an extended (seasonal) period of time:
- Defrost and clean the interior of the refrigerator
- Leave doors open or cracked
If the refrigerator does not cool correctly in DC mode:
- Make sure the power switch is not in the OFF position.
- Make sure the compartment control is at the temperature setting that you wish.
- Make sure that the power source to the refrigerator is serviceable.
- Make sure that the fuse or circuit breaker is intact (See “Over current protection system”)
- Make sure that the refrigerator is correctly installed and that the built in vents are not blocked.
-Makesurethattheambienttemperatureisnotunusuallyhigh(morethan110°F./43°C.)(See“Overheatingshut-o󰀨device
operation”).
- Make sure that the doors are closed.
- Make sure that the door gaskets are sealing correctly.
- Make sure that the air circulation inside the refrigerator is not decreased by foods or by shelves that are covered with plastic, paper,
etc.
- Make sure that hot foods were not placed in the fresh food compartment of the refrigerator.- Make sure that the freezer is
defrosted.
After you make these checks, if the refrigerator does not operate, contact your dealer or an authorized Norcold Service Center.
Art00980
Troubleshooting

Norcold N8DC Series Specifications

General

Brand	Norcold
Model	N8DC Series
Category	Refrigerator
Language	English