NORDIC HOT TUBS | OWNER’S MANUAL |
27
Your new hot tub has been constructed to hold up to the
elements for a lifetime and a little periodic cleaning will keep
it looking new. Below is a list of how to care for the various
components of your tub. Occasionally you will need to drain
and re-ll your hot tub. We recommend every 3 months
depending on the typical bather load and frequency of use.
Water which remains cloudy after shocking is a clue it’s time.
This is the perfect time to clean the shell, siding, and cover
as noted below.
DRAINING YOUR HOT TUB
1. Turn the power off to the hot tub at the GFCI breaker
2. Remove the access panel
3. Locate the drain
4. Remove the safety cap and connect a garden hose. Make
sure to route the hose to a location that will not damage
vegetation or erode sensitive landscaping
5. Rotate the handle on the drain assembly and let it empty
until fully drained. It may be necessary to use a wet/dry
shop vac to remove the last remaining water from the
footwell and seat bases.
6. Close the drain valve, disconnect the garden hose, and
reinstall the safety cap.
7. Reinstall the access panel, clean the shell, siding and
cover (as noted below) and rell your hot tub.
8. Do not turn the power back on until the hot tub is full.
Note: You will need to balance your water since it has been
relled.
PERMASHELL®
PermaShell® cleans very easy because of its durable poly
material. A spray pool and spa cleaner that is low in “suds”
and is applied then wiped off will most of the time be
sufcient. With stubborn stains or marks, a “soft” scrub
cleaner with very low abrasion (elements) will help when
used with a non-abrasive cleaning pad. A Magic Eraser
works as well.
HIGHWOOD® – MAHOGANY, TEAKWOOD,
CHARCOAL, BLACK
Maintenance for Highwood® is to use mild soap and water.
Some strong household cleaners/solvents can cause
damage/fading to the surface of the cabinet. All cleaners
should be tested on an out-of-the-way section of cabinet
before cleaning.
WESTERN RED CEDAR
As with any wood product, maintaining the “new” look
requires a consistent schedule of treating your cabinet
with a quality Tung or Teak Oil product. Either can be easily
applied by wiping it on with a clean rag or sponge.
COVER OR HOT TUB LID
See manufacturer’s warranty and maintenance procedures.
When adding any chemicals or using a spa or hot tub
“shock”, the cover must be removed for 30 minutes.
Failure to remove cover may cause damage to cover.
NOTE: Please visit www.nordichottubs.com for more
information and tips regarding use and cleaning
WARNING: The improper use of any sanitizing system
including Di-Chlor Granular Chlorine could negate our
warranty. The use of Bromine or Chlorine tablets in a oater
or Biguanide Chemicals can potentially damage (fade) the
shell of your hot tub and is not covered under warranty.
Failure to maintain proper chemical balance (pH, Alkalinity,
and Hardness) could also negate your warranty. Nordic
does not recommend the use of any Bromine product with
Ozone. The use of Salt Systems will void the warranty.
PERIODIC CLEANING AND CARE
To Next Page
Loading...
Need help?
General
