8
The Remote Controller will emit a tone when a button is pressed.
Remote Controller (RC-9018M)
Cover shown in the open position.
General Parts
4
5
10
11
6
7
8
9
Remote Controller
Part Number
The part number is printed
on the surface of the cover.
2
1
3
1. Power Button / Indicator (Green)
For turning the Water Heater ON/OFF.
2. PROG Buon / Indicator (Red)
Activate the automatic Water Heater power ON/
OFF setting as determined by the user selected
schedule. (See page 14)
3. ALARM OFF Button / Indicator (Red)
Stop the tone that is emitted when an error occurs.
(See page 32)
4. Speaker
5. Display Screen (See next page)
6. MENU Button
Use to change system settings or to return to the
home screen.
If you press the MENU button and press the /
buttons, “Sys monitor” is sometimes displayed,
however, do not use this mode as it meant for
installation or service technician only.
7. BACK Button
Return to the previous screen while making system
settings or checking status.
8. / Buttons
For setting the hot water temperature (See page
13), the flow meter alarm, and other settings.
9. ENTER Button
Confirm changes made by the user.
10. STATUS Button
Check the status of the system or the number of
installed the Water Heater. (See page 20)
11. Lock Button
Lock Remote Controller operation. (See page 16)
To Next Page
Loading...
Need help?
General
