REAR WHEEL MOUNTING AND ADJUSTING THE CS LENGHT
The FUZZ frame is compatible with 157x12 thru-axle hubs that work with adjustable chainstay length systems. For proper
rear wheel installation and adjustment of the chainstay length please follow the instructions:
- choose the chainstay length by fl ipping the dropout insert over on the non drive side
(it is secured by 2,5mm allen key from the bottom),
- choose the correct brake caliper position for your currently chosen chainstay length
- make sure the wheel is aligned and the disc sits properly in the brake caliper
- put the wheel into the dropouts with the chain set up correctly on a cassette,
- put the 12mm axle through and tighten properly with 8mm allen key.
- secure the axle with 2,5mm allen key bolt on the bottom of the dropout.
ADJUSTING THE BRAKE ADAPTER
INTEGRATED SEAT CLAMP
Before seat post insertion make sure to correct-
ly position the integrated seat clamp wedges.
Edges parallel with seat post
11
Long Chain Stay position
Brake adapter holes for
long chain stay
Brake adapter holes for
short chain stay
Short Chain Stay position
Change the spring and check the correct spring rate for your weight to make sure you get it set up correctly. To achieve a
medium-soft suspension with approximate 30-35% of sag we recommend the following:
For rider weight of :
66-74kg a 350 lbs spring // 74-82kg a 400 lbs spring // 82-90kg a 450 lbs spring //>90 and more a 500 lbs spring
These values are only recommendations. Play around with the spring weights and shock preload adjustment until you fi nd a
setting that suits you best.
FUZZ
To Next Page
Loading...
General