INSTRUCTION: GENERAL INFO
Fork: The frame is designed to work with double and single crown DH/FR forks with 180-220mm of travel. Use of dierent
style of forks or forks with longer travel may result in frame failure, possible injury or even death.
Rear shock: The frame is designed to work with 240x76mm (9.5x3.0”) DH/FR shocks. Use of dierent style of shocks or
shocks with dierent length may result in frame failure, possible injury or even death.
Headset: The FUZZ frame comes with a tapered head tube with 1.5 ZS (bottom: 56mm ID* / top: 44mm ID) and 115mm stack
height. It fits forks with standard 1-1/8” or tapered 1.5 - 1-1/8” steerer tubes. The headset added to the frame works with both 1
1/8” and 1.5” steerers as there are two crown races included. The headset comes with two top-caps: 8mm and 15mm, to suit
riders personal preferences. Additional headset spacers can be added between the headset and the stem/crown. Don’t cut
your steer-tube too low! The process of mounting headsets in the frame should be done by a qualified mechanic.
*Please note that headsets with OD55 mm bottom cups or other internal headsets won’t fit. Only headsets with a bottom
cup with 56m OD will work with the FUZZ frame. The use of a wrong type of headset can be dangerous & can damage the
frame.
BB: The frame is designed to work with 83mm bottom bracket size only and will accept conventional threaded, external BB
standards such as SRAM GXP, Shimano BB80 or FSA MegaExo. Before installation make sure that the BB is clean, lightly
greased, free of dirt and paint. The installation process should be carried out according to the BB manufacturers instruc-
tions.
Chainring sizes: The frame is designed to work with chainrings up to 38t. Max chainring size is only an approximate refer-
ence. It can vary depending on the manufacturer, model, cranks & BB used.
Biggest tire: The frame will fit tires of maximum 26 x 2.6” (will fit 650B x 2.5” tire in long CS position). Note that these num-
bers are for reference only as the size and shape of the tire can vary depending on the manufacturer and rim width.
Brake compatibility: The FUZZ frame is disk brake compatible and it comes with an International Standard IS-2000 disc
brake mount, it will fit discs up to 200mm.
Seatpost & seatclamp: The FUZZ frame works with 30.9mm seatposts and comes with the integrated seat post clamp. Be
carefull not to loose it! Do not extend the seat post above the minimum insertion mark. Maximum seat insertion is 175mm for
S and M size, and 200mm for L size.
WARNING: It is important to make sure that the rear tire won’t touch the saddle when suspension reaches it’s maximum
amount of travel. To check that please compress rear suspension fully without the spring installed onto the rear shock.
REPLACEMENTS
PARTS:
- Fuzz Rocker arm (2 sides)
- Fuzz Kit1: Shock bolts & nuts (2 sets)
- Fuzz Kit2: Rocker bolts & C-clips (2 sets)
- Fuzz Kit3: Clevis bolts (2pcs - set for 1 link)
- Fuzz Kit4: Bearing hardware (4pcs - set for 1 link)
- Fuzz Kit5: Main pivot axle & bolt
- Fuzz Kit6: NS 157mm axle + dropout insert
- Fuzz Kit7: Derailleur hanger (w/bolt)
- Fuzz Kit 8: integrated seat clamp
ACCESORIES:
- Fuzz Kit9: Internal cable routing kit
- Fuzz Kit10: Shock fender
- Fuzz Kit 11: Neoprene CS protector
- Fuzz Kit 12: Protective self-adhesive foil
- Fuzz Kit 13: NS shock mounting hardware (fits: RS, MZ, FOX)
- Fuzz Kit 14: headset (fits standard and taper steer tubes)
- Fuzz Kit 15: removable cableguides
11
SUSPENSION SETTINGS
Suspension settings are a matter of personal preference. Some riders like it plush, some like it firm. However here are some
suggestions of shock settings that you can use as basic guidelines.
Typically, the Fuzz should run with about 30% to 35% sag. To measure sag, push the bottom-out bumper up the shock shaft
until it meets the body of the shock. Gently stand up on the pedals with all your weight on the bike (fully kitted up with body
armour, helmet, neck brace, hydration pack, etc. – it’s important to make the situation as ‘real world’ as possible to give you
the most accurate results) and note how far the bumper displaces.
10
FUZZ
To Next Page
Loading...
General