5
LCD FEATURES
1. PLAY: Active while the unit is actually playing a CD.
2. PAUSE: Active when the unit is paused.
3. CUE: Flashing when the unit is setting a cue point. Lit continuously
when the unit is paused at a cue point.
4. PROGRAM: Used for pre-programming the track order to
automatically be played by the unit. This is a great function if you
need to leave the CD player alone.
5. TIME MODE: (Elapsed) is for showing time as it is taking place.
(Remain) shows how much time is left on a particular track. This
function is controlled by the TIME BUTTON.
6. SINGLE: Shows when the unit is set to Single Play Mode (one track at a time). When this is not lit, it is in Continuous
Play Mode (the CD will play continuously through all tracks). This function is controlled by the SGL button.
7. PITCH: Is lit when the PITCH BUTTON is active.
8. TIME BAR: Shows either time remaining or elapsed depending on the setting of the TIME BUTTON.
9. PITCH/BPM: Shows the percentage change in pitch or current BPM.
10. TRACK: Shows the current track that the unit is playing.
11. MINUTES: Shows the minutes elapsed or remaining depending on mode setting.
12. SECONDS: Shows the seconds elapsed or remaining depending on mode setting.
13. FRAMES: The CD Player breaks down a second into 75 frames for accurate cueing. This shows the frames elapsed or
remaining depending on mode setting.
PLAY, PAUSE & CUE OPERATIONS
PLAY & CUE
Pressing the “PLAY/PAUSE”
button starts the disc. Pressing
the “CUE” button will reset the
disc to the last place where the
disc was started. This is called
the cue point. By alternately
pressing the “PLAY/PAUSE”
button and the “CUE” button,
the disc may be returned and
played from the cue point any
number of times. This function
is called back cue.
PLAY, PAUSE & CUE
When play has been paused
and then started again, the
return position for the back cue
will be updated to this new
position.
EDITING CUE POINT
When the inner dial is turned
while paused at the cue point, it
will move the cue point. You
will hear the track's audio as the
player "scrubs" through the
track until you find where you
want to set your new cue point.
Press “PLAY/PAUSE” then
“CUE” to confirm the new cue
point.
Back Cue Operation
Play Interval
Press "PLAY/PAUSE
To Next Page
Loading...
Need help?
Audio Specifications
Power
