Numark V7 User Manual

8
SETTING UP TO TRANSITION BETWEEN TWO DJs
Numark V7s allow you to transition
smoothly between two DJs (each with his
own computer) without interrupting the
music. To prepare for this, set up a dual-
V7 setup (as described above) then follow
these steps:
AC IN 100V
AC IN 100V
-240V
-240V
50-60Hz 50W
50-60Hz 50W
POWER
POWER
USB
USB
LINK
LINK
HIGH
HIGH
LOW
LOW
RIGHT
RIGHT
LEFT
LEFT
REMOTE
REMOTE
DECK B
DECK B
L
R
L
R
OUTPUT
OUTPUT
DECK A
DECK A
DECK
DECK
LOCA
LOCA
TION
TION
MOTOR
MOTOR
TORQUE
TORQUE
AC IN 100V
AC IN 100V
-240V
-240V
50-60Hz 50W
50-60Hz 50W
POWER
POWER
USB
USB
LINK
LINK
HIGH
HIGH
LOW
LOW
RIGHT
RIGHT
LEFT
LEFT
REMOTE
REMOTE
DECK B
DECK B
L
R
L
R
OUTPUT
OUTPUT
DECK A
DECK A
DECK
DECK
LOCA
LOCA
TION
TION
MOTOR
MOTOR
TORQUE
TORQUE
1. Connect both
V7s' DECK A OUTPUTS to your mixer's left channel (line-level) inputs.
2. Connect both
V7s' DECK B OUTPUTS to your mixer's right channel (line-level) inputs.
3. With a USB cable, the new DJ ("DJ 2") should connect his computer to the V7 that is not connected the
current DJ's ("DJ 1"'s) computer.
4. As DJ 1 is playing his last track, DJ 1 should press the MASTER BUTTON on the unused V7.
5. On the unused V7, DJ 2 can now cue up his first track and fade it in with the mixer.
6. When DJ 2 has finished transitioning into his first track, he should press the MASTER BUTTON the
opposite V7. He can now control Serato ITCH on his computer using both V7s.
7. DJ 1 can now disconnect his computer from the setup without any interruption of the music.
Note: The instructions in this section address a setup with a
mixer that supports multiple line-level inputs on two
channels. However, you may also adapt these instructions
to a fou
r
-channel mixer setup.

Numark V7 Specifications

General

Brand	Numark
Model	V7
Category	Turntable
Language	English