17
Not withstanding any provision of any agreement the fol-
lowing warranty is exclusive.
Ohmic Instruments Company warrants each instrument it
manufactures to be free from defects in material and work-
manship under normal use and service for the period of 1-
year from date of purchase. This warranty extends only to
the original purchaser. This warranty shall not apply to
fuses or any product or parts which have been subjected
to misuse, neglect, accident, or abnormal conditions of
operation.
In the event of failure of a product covered by this war-
ranty, Ohmic Instruments Co. will repair and recalibrate an
instrument returned within 1 year of the original purchase:
provided the warrantor's examination discloses to its satis-
faction that the product was defective. The warrantor may,
at its option, replace the product in lieu of repair. With re-
gard to any instrument returned within 1 year of the origi-
nal purchase, said repairs or replacement will be made
without charge. If the failure has been caused by misuse,
neglect, accident, or abnormal conditions of operations,
repairs will be billed at a nominal cost. In such case, an
estimate will be submitted before work is started, if re-
quested.
THE FOREGOING WARRANTY IS IN LIEU OF ALL
OTHER WARRANTIES, EXPRESSED OR IMPLIED, IN-
CLUDING BUT NOT LIMITED TO ANY IMPLIED WAR-
RANTY OF MERCHANTABILITY, FITNESS, OR ADE-
QUACY FOR ANY PARTICULAR PURPOSE OR USE.
OHMIC INSTRUMENTS COMPANY SHALL NOT BE LI-
ABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSE-
QUENTIAL DAMAGES, WHETHER IN CONTRACT,
TORT, OR OTHERWISE.
If any failure occurs, the following steps should be
taken:
1. Notify Ohmic Instruments Co. giving full details of the
difficulty, and include the model, type, and serial
numbers (where applicable). On receipt of this infor-
mation, service data, or shipping instructions will be
forwarded to you.
2. On receipt of shipping instructions, forward the instru-
ment, transportation prepaid. Repairs will be made
and the instrument returned, transportation prepaid.
SHIPPING TO MANUFACTURER FOR REPAIR OR AD-
JUSTMENT
All shipments of Ohmic Instruments Co. instruments
should be made via United Parcel Service or "Best Way"
prepaid. The instrument should be shipped in the original
packing carton, or if it is not available, use any suitable
container that is rigid and of adequate size. If a substitute
container is used, the instrument should be wrapped in
paper and surrounded with at least four inches of excelsior
or similar shock absorbing material.
CLAIM FOR DAMAGE IN SHIPMENT TO ORIGINAL
PURCHASER
The instrument should be thoroughly inspected immedi-
ately upon delivery to purchaser. All material in the ship-
ping container should be checked against the enclosed
packing list. The manufacturer will not be responsible for
shortages against the packing sheet unless notified imme-
diately. If the instrument is damaged in any way, a claim
should be filed with the carrier immediately. (To obtain a
quotation to repair shipment damage, contact Ohmic In-
struments.) Final claim and negotiations with the carrier
must be completed by the customer.
Ohmic Instruments Company will be pleased to answer all
application or use questions, which will enhance your use
of this instrument. Please address your requests or corre-
spondence to: Ohmic Instruments Company, 508 August
St., Easton, Maryland 21601, ATTN: Technical Support.
Or call Ohmic Technical Support at 410-820-5111.
All rights reserved. This manual may not be reproduced in
complete form without written permission of Ohmic Instru-
ments Company. Test forms may be copied as required by
the original purchaser of the instrument. Information con-
tained within this manual is believed to be accurate and
reliable. However, Ohmic Instruments Company assumes
no liability for its use. Ohmic Instruments Company re-
serves the right to supply its instruments with design
changes and/or component substitutions that may not be
documented in this manual.
WARRANTY
508 August St. Easton, MD 21601
Voice: (410) 820-5111
Fax: (410) 822-9633
www.ohmicinstruments.com
To Next Page
Loading...
Need help?
General
