B6250 Network Guide> 27
PRINTING
To specify the output format of printing, enter the following
command:
-C, [Parameter], [Parameter]
Enter a "," (comma) after -C followed by the parameters which
specify the output format. To specify multiple parameters, separate
them with ",".
For example, to output a file named "file1" 2-sided on A4 to printer
"P001", enter the following command:
%lpr -P P001 -C, DUP, A4 file
Important:
> If the command specified by the -C option exceeds 64
characters, the operation may not function correctly.
PRINTING FROM A MACINTOSH COMPUTER
PRINTING FROM A MACINTOSH COMPUTER
This section explains the installation procedure for printing from a
Macintosh computer.
SYSTEM CONFIGURATION
As the printer supports EtherTalk and LPD protocol, you can print
from Macintosh. NOTE > Printing using the LPD protocol is available
only with the Mac OS X.
TARGET COMPUTERS
The printer supports a Macintosh or Power Macintosh with the
following OS:
• Mac OS 10.2 and up
SET UP PROCEDURE
The setting procedure is as follows:
1. Use the printer Operator Panel or EWS to set the following
port to [Enable].
To Next Page
Loading...
Need help?
General
