Loading paper > 13
> If you have two trays and you are printing from the 1st (upper) tray, you can pull
out the 2nd (lower) tray during printing to reload it. However, if you are printing
from the 2nd (lower) tray, do not pull out the 1st (upper) tray. This will cause a
paper jam.
> For face down printing, make sure the face up (rear) stacker (a) is closed (the
paper exits from the top of the printer). Stacking capacity is approximately
350 sheets, depending on paper weight.
> For face up printing, make sure the face up (rear) stacker (a) is open and the
paper support (b) is extended. Paper is stacked in reverse order and tray capacity
is approximately 100 sheets, depending on paper weight.
> Always use the face up (rear) stacker for heavy paper (card stock etc.).
CAUTION!
Do not open or close the rear paper exit while printing as it may
result in a paper jam.
a
b
To Next Page
Loading...
Need help?
General
