Installing upgrades > 54
M
EMORY
UPGRADE
The basic printer model comes equipped with 256MB of main memory. This can be
upgraded with an additional memory board of 256MB or 512MB, giving a maximum total
memory capacity of 768MB.
Installation takes a few minutes, and requires a medium size cross-head (philips type)
screwdriver.
1. Switch the printer off and disconnect the AC power cable.
2. Press the cover release and open the printer’s top cover fully.
3. Pull down the MP Tray using the depressions (b). Lift the front cover release lever
and lower the front cover.
4.
Remove the screw (a) securing the right-hand side cover.
WARNING!
If the printer has been powered on recently, the fuser will be hot.
This area is clearly labelled. Do not touch.
OI
2. 3.
b
a
b
a
5.
4.
To Next Page
Loading...
Need help?
General
