- 91 -
Scanning to Computer
4
Scanning
Step 1 Connecting Your Machine
and Computer
Select the connection method and follow each
procedure.
● “For Network Connection” P.91
● “For USB Connection” P.95
For Network Connection
Connect your machine to a network with an
Ethernet cable or Wireless LAN connection
(MC342dw, MC362w, MC562w, MC562dw,
ES5462dw MFP, MPS2731mc only), and then
congure the machine’s IP address and other
network information from the operator panel.
You can set the IP address either manually or
automatically.
If there is no DHCP server or BOOTP server on
the network, you need to manually congure the
IP address on the computer or machine.
If your network administrator or internet
service provider species a unique IP address
for the computer and your machine, set the IP
addresses manually.
Note
● You need to congure the network setting of the computer
before this procedure.
● When setting an IP address manually, ask the network
administrator or your internet service provider which IP
address to use. If the IP address is set incorrectly, the
network may go down or Internet access may be disabled.
● To congure the Scan to Computer function via the
network connection, follow these instructions.
- Conform the IP version of the machine to that of your
computer.
- Set [TCP/IP] setting to [Enable] on your machine.
(By factory default, it is set to [Enable].)
- Set [Network TWAIN] setting to [ON] on your
machine. (By factory default, it is set to [ON]. If
it has been disabled, enable it by referring to the
Conguration Guide > “Conguring the Scan to
Computer and Remote Scan” > “Using Functions for
Scan to Computer and Remote Scan” > “Enabling the
Network TWAIN Setting”.)
Memo
● If conguring a small network consisting of only your
machine and a computer, set IP addresses as shown
below (according to RFC1918).
For the computer
IP address : 192.168.0.1~254
Subnet mask : 255.255.255.0
Default gateway : not used
DNS server : not used
For the machine
IP Address Set : Manual
IPv4 Address : 192.168.0.1~254
(select a different value
from the computer)
Subnet Mask : 255.255.255.0
Gateway Address : 0.0.0.0
Network Scale : Small
● To set [Network Scale], press the <SETTING> key
and then select [Admin Setup] > [Network Menu] >
[Network Setup] > [Network Scale].
Connecting using wired LAN
1 Prepare an Ethernet cable and a hub.
Prepare an Ethernet cable (category 5, twisted
pair, straight) and a hub separately.
2 Hold down the power switch for
approximately one second to turn off the
power.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
