To Next Page

To Previous Page

24 Microline 420/421 User’s Guide

Printer Reset

Clearing some error conditions requires that you reset

(reinitialize) the printer. To do this:

1 Press and release

SEL (1) to take the printer off-line.

The SEL light goes out.

2 Press and hold

SHIFT (2), then press the RESET/

CHARACTER PITCH key.

Important!

Pressing

SHIFT + RESET reinitializes the printer, but does not

affect any menu settings and does not reset the printer to the

factory defaults. For information on resetting the printer to

the factory defaults, see “Resetting the Menu to the Factory

Defaults” later in this chapter.

Emulations

• IBM

Proprinter III — factory setting

• Epson

• Oki

MICROLINE

Changing Emulations

1 Make sure paper is loaded.

2 Press and hold

SHIFT (2), then press SEL (1).

3 Press

LF (3).

The following line prints:

Printer Control Emulation Mode IBM PPR

4 Press TEAR (4) repeatedly until the emulation you wish to

select prints in the right-hand column.

5 Press and hold

SHIFT (2), then press SEL (1) to save your

setting and exit the Menu Mode.

Oki ML420 User Manual

Other manuals for Oki ML420