yellowblue
2-57
Speedometer and Odometer
Your speedometer lets you see your speed in both miles per
hour (mph) and kilometers per hour (km/h). Your odometer
shows how far your vehicle has been driven, in either miles
(used in the United States) or kilometers (used in Canada).
Press the E/M (English/Metric) button on the left side of
the instrument cluster to switch the display between
miles and kilometers. Pressing this button will also cycle
all other displays through English and metric units.
You may wonder what happens if your vehicle needs a
new odometer installed. If the new one can be set to the
mileage total of the old odometer, then it must be. But if
it can’t, then it’s set at zero and a label must be put on
the driver’s door to show the old mileage reading when
the new odometer was installed.
Trip Odometer
Your trip odometer tells how far you have driven, in
either miles or kilometers, since you last reset it.
Press the E/M (English/Metric) button on the left side of
the instrument cluster to switch the display between
miles and kilometers.
The trip odometer is displayed by pressing the TRIP
button. To reset it to zero, press TRIP to display the trip
odometer, then hold the button for about three seconds
until the display resets.
Tachometer
The tachometer displays the engine speed in revolutions
per minute (rpm).
NOTICE:
Do not operate the engine with the tachometer in
the red area. Engine damage may occur.
Warning Lights, Gages and Indicators
This part describes the warning lights and gages that
may be on your vehicle. The pictures will help you
locate them.
Warning lights and gages can signal that something is
wrong before it becomes serious enough to cause an
expensive repair or replacement. Paying attention to
your warning lights and gages could also save you or
others from injury.
To Next Page
Loading...
Need help?
General
