To Next Page

To Previous Page

–

¦ : Recommended combination.

¦* : Usable, but image be dark depending on NA.

–– : Not usable, or applicable objective is not available.

¦** : A phase contrast (Ph) objective is necessary for phase contrast observation. The Ph objective is not

available for the UPlanFI100XOI3.

4 Turning the Power Supply Unit On

Set the main switch to “ I ” (ON). The arc will stabilize in 5 to 10 minutes after ignition.

}The discharge type mercury burner may not be ignited from the beginning on rare occasions due to its characteristics.

In this case, set the main switch to “ ” (OFF), wait for 5 to 10 seconds, then set it again to “ I ” (ON).

#To extend the mercury burner life, do not turn the mercury burner off for 15 minutes after ignition.

#The mercury burner cannot be reignited until the mercury vapor has cooled down and liquefied. Before re-igniting

a mercury burner, wait for about 10 minutes after the last time it was turned off.

}For the shake of safety, the power supply to the lamp housing is shut down if the lamp housing is opened while the burner

is on. If this happens, set the main switch to “ ” (OFF), wait for more than 10 minutes, then set it again to “ I ” (ON). Do not

open the lamp housing until it has cooled down enough.

#To reset the hour counter, hold its reset button till “000.0” is displayed.

Objective

Reflected light fluorescence

U, V, BV B, IB, G, IY

Phase contrast

difference

Transmitted

light DIC

UPlanApo 4X

10X

10X O

10X W

20X

20X O3

40X

40X O Ι 3

60X

60X W3

100X O Ι 3

PlanApo 40X

60X O3

100X O3

UPlanFI 4X

10X

20X

40X

60X O Ι 3

100X O, OΙ3

UApo

20X 3/340

20X W3/340

40X 3/340

40X

OΙ 3/340

40X W3/340

–

¦**

–

¦**

–

¦**

–

¦**

–

¦**

–

¦*

–

¦**

–

UIS Series

Brand	Olympus
Model	BX-URA2
Category	Microscope
Language	English

Olympus BX-URA2 User Manual

Table of Contents

Questions and Answers:

Olympus BX-URA2 Specifications

Related product manuals