26
2 6-Position Barrier Filter Slider U-RSL6EM
}This filter slider is for use with the BX-URA2 or BX-RFA illuminator and accommodates a total of six barrier filters.
Slider knob
Filter Mounting Procedure
1 Remove the slider knob on the opposite end to the extremity where the slider inscription is engraved.
2 Gently place the barrier filters in filter insertion positions.
#Insert the filters so that their arrow inscriptions on the side face downward.
3. If it is required to inscribe the type of the inserted filter, write it on a commercially available round sticker with a diameter of
less than 8 mm, and attach it to the specified inscription sticker position.
#Make sure that the sticker does not deviate from the specified circular area. Otherwise, the slide will be caught in
motion.
4. Gently insert the filter slider from the right of the analyzer inlet slot on the illuminator, and attach the slider knob which has
been removed in the above.
5. Use the joint plate if you want to interlock this filter slider with the U-RSL6 fitter slider. (For the attaching method, see the
description on the U-RSL6.)
Inscription sticker position
Diameter 8 mm, depth 1 mm
Light shield position
Barrier filter insertion positions (x 6)
Joint plate
Diameter 25 mm, thickness max. 5 mm
NOTES
· Be sure to insert each filter in the specified orientation. Otherwise, the filter cannot be set in the correct positioning.
· For safety, insert the provided light shield plates in the unused filter positions.
Light shield plate (x 4)
To Next Page
Loading...
Need help?
General
