6
QUESTIONS? 1-800-MOUNT-IT (1-800-668-6848)
Disclaimer – OmniMount Systems has extended every e ort to ensure to accuracy and completeness of
this manual. However, OmniMount Systems, Inc. does not claim that the information covers all
installation or operational variables. The information contained in this document is subject to change
without notice or obligation of any kind. Regarding the information contained herein, OmniMount Systems,
Inc. makes no representation of warranty, expressed or implied, and assumes no responsibility for accuracy,
su ciency, or completeness of the information contained in this document.
WARNING: FAILURE TO READ, THOROUGHLY UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS CAN
RESULT IN SERIOUS PERSONAL INJURY, DAMAGE TO PERSONAL PROPERTY, OR VOIDING OF FACTORY WARRANTY!
It is the responsibility of the installer to ensure all components are properly assembled and installed using the instructions provided. If you do not understand
these instructions or have any questions or concerns, please contact customer service at 1-800-668-6848 or info@omnimount.com. Do not attempt to install
or assemble this product if the product or hardware is damaged or missing. In the event that replacement parts or hardware are needed, please contact
Customer Service at 1-800-668-6848 or info@omnimount.com. International customers needing assistance should contact the Dealer from which they
purchased the product. The included hardware is designed for use on vertical walls constructed of wood studs or solid concrete. A wood stud wall is
de ned as consisting of a minimum of 2x4 wooden studs (2" wide by 4" deep) with a maximum of 5/8" drywall. A concrete wall is de ned as solid concrete
with a minimum depth of 6" (152 mm). The included hardware is not designed for use with metal studs or cinderblock walls. If you’re uncertain about the
construction of your wall, then please consult a quali ed contractor or installer for assistance. For a safe installation, the wall you are mounting to must
support 4 times the weight of the total load. If not, then the surface must be reinforced to meet this standard. The installer is responsible for verifying that
the wall structure and hardware used in any installation method will safely support the total load.
To Next Page
Loading...
Need help?
General
