USING THE DEVICE
17
Using the Memory Function
The monitor automatically stores the results up to 14 sets.
Note: If the memory is full, the monitor will delete the oldest value.
To View the Measurement Values Stored in Memory
1. Press the button.
The Memory number appears for a second
before the pulse rate is displayed.
The newest set is numbered “1”.
2. Press the button repeatedly to view the values stored in
memory.
To Delete All the Values Stored in Memory
1. Press the button, while the memory symbol appears.
2. While holding the button
down, press the START/STOP
button for
more than 3 seconds.
Note: You cannot partially delete the values stored in the memory.
To Next Page
Loading...
Need help?
General
