11
EN
2. Preparing the nebulizer for use
Warning:
Clean and disinfect the nebulizer kit, mask or mouthpiece before using them when as follows:
- the first time after purchase.
- if the device has not been used for a long period of time
- if more than one person uses the same device
For the instructions, refer to “Cleaning and disinfecting” section.
For directions on cleaning and disinfecting refer to Section 4 (page 16-18).
Note: Make sure that the air filter is changed regularly. Refer to Section 7 “Changing the air filter”
(page 20).
2.1 Connecting AC adapter
1. Make sure that the power switch is turned off.
Check that the power switch is in the off ( ) position.
2. Inserting the power plug of the AC
adapter into the power connector
on the compressor.
3. Plug the AC adapter into a power
outlet.
Notes:
• When disconnecting the AC
adapter, unplug the AC adapter
from the power outlet before
removing the power connector on
the compressor.
• Do not place the device in a location
where it is difficult to disconnect the
power cord.
Power Plug
Power Connector
Power Outlet
Operating instructions
To Next Page
Loading...
Need help?
General
