17
4.Cleaning and disinfecting
EN
4.2 Disinfecting
Always disinfect the parts after the last treatment of the day. If the parts are heavily stained,
replace them with new ones.
To select a method for disinfection, refer to the table on page 18.
Caution:
Do not use an autoclave, EOG gas sterilizer or low temperature plasma sterilizer.
Note: The printing may come off the surfaces of kids accessory as a result of repeated washing and
disinfecting.
Handling the Vaporizer Head
The vaporizer head is an important part that is used to
vaporize medication.
Be sure to observe the following precautions when handling it.
Notes:
• Always wash the vaporizer head after each use.
• Do not use a brush or pin etc., to clean the parts.
• When disinfecting the parts by boiling, be sure to boil them in plenty
of water.
• Do not boil vaporizer head together with other objects, other than
applicable nebulizer accessories.
• Do not use a microwave oven, dish dryer or hair dryer to dry parts.
To Next Page
Loading...
Need help?
General
