Omron E5*C-B Series User Manual

6 - 89
6 Parameters
E5@C Digital Temperature Controllers User’s Manual (H174)
6-8 Advanced Function Setting Level
6
hctm
Heating/Cooling Tuning Method
The control must be set to heating/cooling control
and 2-PID control.
This parameter sets the tuning method that is suitable for the cooling control characteristics.
• Air Cooling/Water Cooling
Control that is suitable for an application that does not have linear cooling characteristics
(such as plastic molding machines) is performed. The response is fast and the response
characteristics are stable.
• Linear
Control that is suitable for an application that has linear cooling characteristics is
performed.
ompw
Minimum Output ON/OFF Band
A Standard Model must be used.
The control must be set to 2-PID control.
This parameter sets the minimum ON/OFF width of the outputs that are assigned for the
heating and cooling control outputs. You can set this parameter to prevent deterioration of a
relay output.
Function
Setting
Setting range Default
0: Same as heating control
1: Linear
2: Air cooling
3: Water cooling
0
Air cooling
Water cooling
Linear
100
1000
MV (cooling) [%]
Cooling
capacity
[%]
Cooling Characteristics
Function
Setting
Setting range Unit Default
0.0 to 50.0 % 1.0

Omron E5*C-B Series Specifications

General

Brand	Omron
Model	E5*C-B Series
Category	Controller
Language	English