H5S
17
Cyclic Operation
Weekly, 2 Circuits Yearly, 2 Circuits Yearly, 4 Circuits
Example: ON for 5 minutes and OFF for 1 hour 55 minutes
repeatedly from 8:00 to 19:00 on Sunday.
1. Set the Mode Switch to P1 or P2. *1
(The Time Switch enters program
setting mode.)
→For 4-circuit models, refer to
page 18.
2. Press .
(The Time Switch enters cyclic
program setting mode.)
3.
Press the Day Keys to turn ON the bar
( ) at the Sunday position.
Set the start time to 8:00
with and
. *2
4. Press .
Set the stop time to 19:00 with
and . *2
5. Press .
Set the ON time period with and
. *2
6. Press .
Set the OFF time period with and
. *2
7. Press to enter the settings.
*1 If one or more programs have already been set, the display starts
showing the set programs.
To add another program, press repeatedly until “--:--“
is displayed.
*2 Holding down the and Keys rapidly advances the value.
Pressing decrements the value of the key that was last
pressed.
Note:
• If multiple settings are required, repeat steps 2 through 7.
• All the start/stop times, and ON/OFF time periods must be set.
• All of the weekly programs for the selected circuit (output) can be
checked by pressing in program setting mode.
• When the Mode Switch is set to P1 or P2 (to PRGM for 4-circuit
models), the Time Switch stops automatic operation. To forcibly
turn ON or OFF the output, use the Output ON/OFF Switches.
• Set cyclic operation so as not to overlap other operations in
individual circuits.
• The set data will be cleared if the Output Setting Switch is moved
between the TIMER and PULSE positions after the data has been
set.
SUN
8:00
Start
1 h 55 min
5 min
19:00
Stop
Shaded portion
indicates blinking of
the indicator.
SUN
MON
TUE
WED
THU
FRI
SAT
Number of
remaining steps
P1
P2
RUN
PULSE
TIMER
CYCLE
SUN
MON
TUE
WED
THU
FRI
SAT
h
m
SUN
MON
TUE
WED
THU
FRI
SAT
WRITE
h
m
SUN
MON
TUE
WED
THU
FRI
SAT
WRITE
h
m
SUN
MON
TUE
WED
THU
FRI
SAT
WRITE
h
m
SUN
MON
TUE
WED
THU
FRI
SAT
WRITE
WRITE
h
m
WRITE
To Next Page
Loading...
Need help?
General
