20
SETTING PERSONAL DATA
Set the gender to male or female.
1) Press the UP or DOWN button to change the gender.
2) Press the SET/MODE button.
The gender is set.
The default value for height blinks on the display.
Set the height between 3' 4" and 6
' 6 3/4".
(Display range in metric display mode: 100.0 cm to 199.5 cm)
1) Press the UP or DOWN button to change the height.
2) Press the SET/MODE button.
The height is set.
The current settings for age, gender and height appear in this sequence on the display.
The 0.0 lb symbol appears on the display. You can now take a measurement using the Personal
Profile Number you selected or the Guest mode.
Refer to HOW TO TAKE A MEASUREMENT on pages 22 to 26.
CHANGING PERSONAL DATA
If your personal data changes, the information in the Personal Profile Number you selected must be
changed for measurement results to be calculated correctly.
1. Press the Power Switch to turn the monitor ON.
The CAL symbol blinks on the display, then the display changes to 0.0 lb.
Wait until 0.0 lb appears on the display.
SETTING THE GENDER
SETTING THE HEIGHT
To Next Page
Loading...
Need help?
General